For Furnace repair in Jackson MI, like us on Facebook!
For Boiler repair in Chelsea MI, visit us on Google!
For Geothermal repair in Albion MI, follow us on Twitter!
Aspen One Hour Heating & Air Conditioning has certified technicians to take care of your Furnace installation near Chelsea MI.
Always on Time…Or You Don′t Pay a Dime
Always on Time…Or You Don′t Pay a Dime
(517) 879-2049
See what makes Aspen One Hour Heating & Air Conditioning your number one choice for Boiler repair in Albion MI.
Always on Time…Or You Don′t Pay a Dime
Always on Time…Or You Don′t Pay a Dime

How is Water Treated

How is Water Treated

How Water is Treated

Prechlorination

Chlorine is added to the raw as it enters each plant. Chlorine kills microorganisms such as bacteria, protozoa, and viruses that may cause illness in humans. Chlorine also prevents the growth of algae at the treatment plant that may interfere with treatment of water and cause taste and odor problems. Enough chlorine is added to maintain a residual of 1 part per million or residual chlorine in water after filtration. A chlorine residual is needed to prevent re-growth of bacteria in the piping network otherwise known as the distribution system.

Coagulation/Flocculation

Alum (aluminum sulfate) is added to the water to destabilize natural fine particulate matter suspended in water. This process in known as coagulation. These particles enter water through land erosion, airborne contaminants, decay of natural organic matter such as plants and animal wastes, and discharges resulting from human activities. The impurities found in water suspensions consist of charged colloids (colloid - a very small solid suspended in water which varies in size, density and electric charge) ranging in size from 5 nm to 1 um and particulates greater than 0.5 mm. Most of these particles will not settle by gravity due to their charge and because they are lighter than water (their density is less than water). The addition of alum causes these particles and colloids to clump together to form heavier particles which will settle in water.

Alum is added quickly to the water at the plants using mechanical mixers. This process is known as Rapid Mix. After passing through the Rapid Mix process, the water travels through flocculation basins where it is gently stirred by slow moving paddles. Gentle mixing brings small particles into contact so that they will collide, stick together, and grow to a size that will readily settle. These large particles are referred to as floc. Formation of proper floc is necessary for particles to be removed during sedimentation and filtration.

Sedimentation

After flocculation, the water and floc moves slowly through large basins known as sedimentation or settling basins. The water moves very slowly through these basins due to their large size. This allows the floc to settle to the bottom of the basin. The floc that falls to the bottom of the basins is collected into a hopper by large rotating scrapers where it is removed several times daily by the plant operators. Clear water above the floc layer (referred to as treatment residuals) flows out of the sedimentation basin and to the filters. Removal of particles in the sedimentation basin improves the operation of the filters that comprises the next treatment process after sedimentation.


The sedimentation process removes many particles including clay and silt based turbidity, natural organic matter, and other associated impurities. These impurities include microbial contaminants, toxic metals, synthetic organic chemicals, iron, manganese and humic substances. Humic substances come from soil are produced within natural water and sediments by chemical and biological processes such as the decay of vegetation. Removal of humic substances from drinking water is desirable since they form disinfection byproducts when chlorine is added to the water. At high concentrations, disinfection by-products such as trihalomethanes are a public health concern.

Filtration

The last step in purifying the water is accomplished by passing water through a bed of sand and gravel. As water filters through the sand, the remaining particles of suspended matter are trapped in the sand bed. In the filtration process, water flows on top of the sand bed and travels through the bed until it is collected at the bottom in underdrains. Filtered water flows from the underdrains into clearwells or filtered water reservoirs. The rate of filtration is regulated using controllers. The filters must be cleaned periodically as material becomes trapped in the filter and reduces the rate of filtration. Cleaning of the filters is also needed to prevent solids from passing through the filters into the filtered water. To keep the filters operating at their best performance, the filter operators take each filter out of service so they can be backwashed. Backwashing cleans the filters by forcing clean water backward through the sand to remove the solids which are deposited in waste drains. Filters are backwashed on a rotating schedule to ensure that plants can continuously operate.

Fluoridation

Fluoride is added to the filtered water at each of the plants to reduce tooth decay. The plants maintain fluoride levels of approximately one part per million in the treated water.

Post-chlorination

If needed, additional chlorine is added to the finished water that leaves the water plants. Low levels of chlorine (approximately 0.2 to 1.0 part per million) must be maintained in the distribution systems pipes and home plumbing to prevent the growth of microorganisms.

Corrosion Control

Lime is added to the treated water at the water plants before the water is added to the distribution system. Lime (or calcium oxide) is added to raise the pH of the water to a level of about 8 standard units. The process reduces the ability of the water to corrode water mains and home plumbing materials such as copper, lead, and brass. Corrosive water can dissolve lead and copper. Excessive levels of dissolved lead and copper are public health concern particularly for young children.


Source: http://publicworks.baltimorecity.gov

24 Hour Emergency Service (517) 879-2049 or Schedule Service Online
24 Hour Emergency Service
(517) 879-2049
Schedule Service Online
 
Contact Info
 
Address:  4131 W. Michigan Ave.
Jackson, MI 49202
Toll Free:  (888) 782-7736
Business Hours:
Monday - Friday: 8:00am - 5:00pm
24/7 Service  —  NO OVERTIME CHARGES!
Schedule an Appointment
Get an Estimate
 
Payment Options
 
For Furnace in Jackson MI, we accept most major credit cards.
 
We accept check for Boiler repair service provided in Chelsea MI.
We accept cash for Heating repair service provided in Albion MI.
 
Financing Options
Connect With Us:
For Furnace repair in Jackson MI, like us on Facebook!
For Boiler repair in Chelsea MI, visit us on Google!
For Geothermal repair in Albion MI, follow us on Twitter!
 
Send Us a Message
 
Check out our Geothermal repair service in Albion MI
Find out ways to save energy and money with Aspen One Hour Heating & Air Conditioning Geothermal repair service in Chelsea MI
Allow our techs to repair your Furnace in Jackson MI
Allow Aspen One Hour Heating & Air Conditioning to repair your Geothermal in Albion MI
Get your Furnace replacement done by Aspen One Hour Heating & Air Conditioning in Jackson MI
Aspen One Hour Heating & Air Conditioning, ready to service your Boiler in Albion MI
Call Aspen One Hour Heating & Air Conditioning for great Furnace repair service in Jackson MI
Trust our techs to service your Boiler in Chelsea MI
Email us any questions about our Boiler repair service in Albion MI
Join our maintenance plan for easy service for your Boiler unit in Jackson MI
Schedule a Geothermal repair service in Jackson MI
Trust your home comfort to us for your next Boiler in Chelsea MI
See what your neighbors are saying about our Furnace repair service in Chelsea MI
Leave the maintenance stress to our technicians on your next Geothermal service in Chelsea MI
We stand behind our Heating company's work in Chelsea MI.
Save money on your next Boiler installation in Albion MI.
When we service your Furnace in Albion MI, your satifaction means the world to us.
Read our Boiler repair service's testimonials in Jackson MI.
We offer 24/7 emergency Boiler repair service in Albion MI.
To schedule your Geothermal installation in Chelsea MI, just email us!
Want to be a Furnace repair service technician in Jackson MI? - Call us.
Sign up for our Boiler maintenace plan in Jackson MI to ensure your home stays comfortable.
We service most Boiler brands and models near Chelsea MI.
For Furnace in Jackson MI, we accept most major credit cards.
We accept cash for Heating repair service provided in Albion MI.
We accept check for Boiler repair service provided in Chelsea MI.
For information on Furnace installation near Albion MI, email Aspen One Hour Heating & Air Conditioning.
Improve your indoor air quality in Albion MI by having a clean Boiler.
We specialize in Boiler service in Jackson MI so call Aspen One Hour Heating & Air Conditioning.
We excel in Furnace repair in Jackson MI
Let us do your Air Conditioner repair service in Jackson MI.
Join our maintenance plan for easy service for your Boiler unit in Jackson MI
Trust your home comfort to us for your next Boiler in Albion MI
See what your neighbors are saying about our Furnace repair service in Chelsea MI
Leave the maintenance stress to our technicians on your next Geothermal service in Chelsea MI
Home   |   Email Us   |   Schedule Service   |   Get a Quote   |   Maintenance   |   Guarantees   |   Employment   |   E Store   |   Search Site
Home   |   Email Us   |   Schedule Service
Get a Quote   |   Maintenance   |   Guarantees
Employment   |   E Store   |   Search Site
Google Map of Aspen One Hour Heating & Air Conditioning
Click to view full map